DSPIAE – CJ-M01 Cutting mat For Angle Cutting Station
Replacement Cutting Mat for AT-CJ Angle Cutting Station
Replaceable Cutting Mat
Free replacement of the newly upgraded mini cutting mat.
Cutting mat replacement procedure:
1. Remove each horizontal and sector baffle plates from the cutting station.
2. Use included hex wrench to remove blade fastening screw and blade.
3. Use hot air from a hair drier to heat the cutting mat for 2-3 minutes.
4. Use a pry bar with flat end to lift off the cutting mat to be replaced.
5. Glue remover may be used to get rid of any remained residues.
6. Remove the backing paper from the new cutting mat and carefully place it in place.
7. Re-install blade, sector plates and horizontal plates.
*hair drier, pry bar and glue remover not included in this product and should be
prepared by user’s own source.
